Lighting control, especially in commercial buildings such as office blocks or shopping malls, can often be taken for granted. However, you should never overlook the benefits that a world-class system can deliver.
Let’s take a look at just why the RAPIX Lighting Control System is a perfect match for your commercial lighting setup.
Exactly what is the RAPIX Lighting Control System?
To put it simply, the RAPIX Lighting Control System is an advanced, yet simple technology designed and developed based upon DALI and Ethernet.
Both of these are International Standards, meaning that the system can be used quickly and efficiently by technicians. There is no unwieldy custom interface – DALI and Ethernet are internationally understood, so think of them as a universal language that everyone can work with. This can deliver a certain peace-of-mind, as you won’t feel tied to a certain developer or contractor due to one niche system – all technicians can understand RAPIX.
It’s this that makes the system so simple, as there is no need for middle-layer control as with other lighting setups. Additionally, RAPIX can save you both time and money with its simple installation and easy operating.
Here are a few reasons that demonstrate this statement.
RAPIX can save you both time and money with its simple installation, easy operating and lack of a need to troubleshoot afterwards.
A design for life
The RAPIX system has been designed to work seamlessly with both Ethernet and DALI – no other services, gateways or devices are needed. This means that the system itself is simplified, so that there is a much smaller risk of anything actually going wrong with the RAPIX once it has been installed.
The RAPIX system is streamlined, so there are fewer products for it to look after – that means that it can deliver more power, too.
Indeed, the entire system is far easier to set up than other controlled lighting solutions, and it’s faster to commission, too. By cutting away all the unnecessary hardware used in some lighting systems, the minds behind the RAPIX have created a solution that’s easy on the wallet, and your peace-of-mind.
Because the RAPIX Lighting Control System uses both DALI and Ethernet as its base technologies, there is far less legwork for contractors installing the setup to go through. This means that the system will be up and ready as quickly as possible, cutting out any long waits that could occur should a more complicated lighting control system be used.
Additionally, because there are fewer products on board with the RAPIX, it uses less board space – meaning it has extra room on which to focus its power.
The RAPIX system was designed with simplicity and ease-of-use in mind, without compromising on effectiveness at the task at hand. In respect of this, should the need arise to deliver a new project both on time and within budget, you’ll never need to worry about overshooting again.
Because the RAPIX system is embedded with the International Standards of DALI and Ethernet, as well as being built with 128-bit encrypted and authenticated communications, it’s among the most secure commercial lighting systems out there.
A bespoke commercial lighting solution
In creating the RAPIX Lighting Control System, the fine minds at Aesthetics started their ambitious project completely from scratch. This means that, free of the constraints that can come with developing existing systems, Aesthetics could devise a technology that is cutting-edge not only today, but will continue to be a benchmark by which others are measured tomorrow.